ECONOMIZER (SUMMER/WINTER) OVERHEAD GREASE EXHAUST HOODS

• 18 gauge type 304 (or optionally type 430) stainless steel
• Exterior seams continuously welded, liquid tight, ground and polished
• Patented adjustable air nozzles (U.S. Patent No. 4,117,833)
• Aluminum face discharge grilles with insulated volume damper
• Insulated supply plenum
• Double Wall end panels
• UL and NSF Listed
• Meets NFPA 96 and National Electrical Code requirements
• Incandescent light fixtures
• Full length pitched grease trough with removable grease cup
• Aluminum baffle type filters
• Factory installed collars
• Supply air fire damper
• Hanger brackets

	SUBMITTAL	CATALOG	SPECIFICATION
S-W Wall Hood	PDF	PDF	VIEW / WORD / PDF
S-W Double Island Hood	PDF	PDF	VIEW / WORD / PDF
OTHER INFORMATION:
Filters	PDF	PDF
Lights		PDF
Installation and Maintenance Manual (PDF)
Collar Installation Manual (PDF)
Balancing Manual (PDF)

• Pitched hood (shorten the front height for low ceiling application; 24" minimum)
• Welded hood sections for single piece length over 12' to 16' maximum
• Supply air balancing damper
• Exhaust air fire damper
• Exhaust air balancing damper
• Motorized exhaust air damper
• Stainless Steel face discharge grilles with insulated volume damper
• Standoff spacer on back of hood (uninsulated or insulated)
• Fluorescent lights
• Stainless steel baffle type filters
• Flame Gard filters
• Loose or mounted switches & pilot lights
• 16 or 14 gauge construction
• End skirts (PDF)
• Back splash (uninsulated or insulated) (PDF)
• Top enclosure (PDF)
• Finished back on wall hood (single island application)
• Painted hood exterior
• Sensor for automatic exhaust fan start
• Cabinet on end of hood for fire suppression equipment & controls (PDF)
• Installed fire protection (PDF)
• Melink^® controls (PDF)

S-W hoods are available in a single section in any increment of length from 4' to 16' (two sections recommended for hoods over 12' in length.  Longer lengths are obtained by butting multiple sections together utilizing factory supplied welded joint covers.

S-W hoods are available in any increment of capture width from 3' to 5' 6".

The height for non-pitched hoods can vary in any increment from 2' to 3'. The minimum front height for pitched hoods in 2' 0" with a minimum back height of 2'.

S-W double island hoods are typically S-W wall hoods back to back, with an available option of single piece construction up to 12' long by 8' wide.