KEES, INC. is a manufacturer of a wide variety of accessories and specialty items for the commercial sheet metal HVAC, architectural specialties and food service industries.

STANDARD CONSTRUCTION

Exhaust only grease exhaust hoods are constructed of 18 gauge, type 304 stainless steel with a satin polish. All exterior seams are continuously welded, liquid tight, and are ground and polished to match the original finish of the material. The hoods are UL and NSF listed, meet the requirements of NFPA 96 and the National Electrical Code. The hoods include incandescent light fixtures on approximately 3 foot centers wired to a junction box on top of the hood, full length pitched grease trough with removable grease cup, aluminum baffle type filters, hanger brackets and factory installed collars and supply air fire damper.

Construction/submittal drawings are available in PDF format, with some drawings in standard (read only) and form (text boxes) format.  You will need Acrobat Reader to view and print standard format or Adobe Acrobat to utilize text boxes.  Acrobat Reader is available at no charge from the Adobe Website.  You will be able to follow the links below to open and view.  Use the back arrow to return to this page.

Available Models:

•	KA Wall Hood	Std PDF	Form PDF
•	KA Wall Hood w/ Rear Supply Plenum	Std PDF	Form PDF
•	KA Wall Hood w/ Front Supply Plenum	Std PDF	Form PDF
•	KB Single Island Hood	Std PDF	Form PDF
•	KB Double Island Hood	Std PDF	Form PDF
•	KB Double Island Hood w/ Front Supply Plenum	Std PDF	Form PDF

OPTIONS AND ACCESSORIES

Available options include: pitched hood (shorten the front height for mounting in low ceiling applications; 12 inch minimum front height), sloped front, welding hood sections together for single piece construction longer than 12' (16' maximum single piece length), exhaust air fire damper, standoff spacer on back of hood (uninsulated or insulated), insulated rear air supply plenum (back return plenum), insulated front supply plenum, fluorescent lights, recessed light fixtures, no lights, stainless steel baffle filters, Flame Gard filters, loose or mounted switches & pilot lights, 16 or 14 gauge construction, end skirts, back splash (uninsulated or insulated), top enclosures, finished back on wall hood (wall hood used for a single island application), painted hood exterior, cabinet on end of hood for mounting fire suppression hardware and/or controls, and installed fire protection.

• Mounted Switch(s)
• Skirt & Back Splash
• Cabinet on End of Hood
• Fire Suppression System

SIZE AVAILABILITY

KA hoods are available in a single section in any increment of length from 4' to 16' (two sections recommended for hoods over 12' in length). Longer lengths are obtained by butting multiple sections together utilizing factory supplied welded joint covers. KA hoods are available in any increment in width from 3' to 6' 6". The height for non-pitched hoods can vary in any increment from 2' to 3', the minimum front height for pitched hoods is 1' with a minimum back height of 2'.

KB hoods are 2 or more KA hoods back to back. The KB single island hood is available in a single section up to 12' long by 8' wide.

TYPICAL SPECIFICATIONS

AVAILABLE MODELS

• Energy Saving (Short Cycle) Overhead Grease Exhaust Hoods
• Exhaust Only Overhead Grease Exhaust Hoods
• Tempered Air (Compensating) Overhead Grease Exhaust Hoods
• Energy Saving (Summer/Winter) Overhead Grease Exhaust Hoods
• Energy Saving Retro-Fit Hood Conversion Kits
• Exhaust Only Back Shelf and Oven Grease Exhaust Hoods
• Exhaust Only Overhead Moisture or Heat Only Exhaust Hoods